Panasonic MINAS A5 Two-Way Radio User Manual


 
2-60
The connector X7 of the front panel is for monitor output.
Analogue output : 2 systems
Digital output : 1 systems
In both cases, it is possible to switch the output signal by setting parameters.
Connector X7
Manufacturer’s part No.: 530140610
Manufacturer: Japan Molex Inc.
61
X7
Measuring
instrument
Output circuit
1
Nї
Nї
AM1
DM
4
GND
3
Nї
AM2
2
Application Symbol
Connector
Pin No.
Contents
Analogue monitor
output 1
AM1 1
2XWSXWWKHDQDORJXHVLJQDOIRUPRQLWRU
7KHDPSOLWXGHRIWKHRXWSXWVLJQDOLV9
2XWSXWLPSHGDQFHLVN::KHQ
connecting a measuring instrument, check
its input circuit for impedance matching.
Analogue monitor
output 2
AM2 2
Signal ground GND 3 Connected to ground of control circuit.
Digital monitor
output
*1
DM 4
2XWSXWWKHGLJLWDOVLJQDOIRUPRQL
tor.
2XWSXWYROWDJHLV&026OHYHOFRPSDWLEOH
2XWSXWLPSHGDQFHLVN::KHQ
connecting a measuring instrument, check
its input circuit for impedance matching.
NC 5 Do not connect.
NC 6 Do not connect.
*1 Position, Velocity, torque, Full closed type.
NC on Only for position control type. Leave this pin unconnected.
3DUDPHWHUUHUDWHGWRPRQLWRURXWSXW
Parametr No.
Title
Function
Class No.
416
Type of analog
monitor 1
Select the type of monitor for analog monitor 1.
417
Analog monitor 1
output gain
Set up the output gain of analog monitor 1.
418
Type of analog
monitor 2
Select the type of monitor for analog monitor 2.
419
Analog monitor 2
output gain
Set up the output gain of analog monitor 2.
420
Type of digital
monitor
Select type of the digital monitor.
421
Analog monitor
output setup
Select output format of the analog monitor.
*1 Position, Velocity, torque, Full closed type.
Only for position control type is not provided with this function.
2
Preparation
9. Wiring to the connector, X7
Monitor output
Remarks
Related page
;WR;DUHXVHGIRUWKHVHFRQGDU\FLUFXLW7RFRQQHFWWKHVHWHUPLQDOVWRWKHSULPDU\SRZHU
supply (particularly, the 24 VDC power supply for control, the 24 VDC power supply for brake,
and the 24 VDC power supply for regenerative resistor [H-frame only]), insulation is required.
Do not connect these terminals to the same power supply.
3´'HWDLOVRISDUDPHWHUµ3´&RQQHFWRU.LWIRU$QDORJ0RQLWRU6LJQDOµ