Filter
Top Products
90 CHAPTER 2: CONFIGURING THE DIRECTORY SERVER
Figure 24 Directory Server’s Main Page
Configuring a Call
Route through the
Web Provisioning
Server
To add a call route using the web provisioning server:
1 Follow the steps according the “Accessing the Directory Server
Configurables” section on page 89.
2 Add an end point. For instructions, go to the “Adding End Points”
section on page 108.
3 Add a pattern for the end point. For instructions go to the “Adding
Patterns” section on page 91.
4 Add an out dial pattern for the end point. For instructions go to the
“Adding Out Dial Patterns” section on page 92.
5 Assign the out dial pattern to the end point. For instructions go to the
“Adding or Editing Out Dial Patterns of End Points” section in page 112.
6 Add a route. For instructions go to the “Adding Routes” section in
page 118.
7 Add URI Route Map. This associates the pattern with the route. For
instructions go to the “Adding URI Route Maps” section on page 127.