Filter
Top Products
202 CHAPTER 9: MAINTAINING THE V7000 IP TELEPHONY SUITE
Call Processor
Maintenance
This section provides maintenance tasks that are specific to just the call
processor.
Starting the Call
Processor
To start the Call Processor:
1 Log on to the machine hosting the Call Processor.
2 Navigate to the /opt/3com/VCX/callprocessor/bin directory.
3 Enter this command:
./callp start
Restarting the Call
Processor
To restart the Call Processor:
1 Log on to the machine hosting the Call Processor.
2 Navigate to the /opt/3com/VCX/callprocessor/bin directory.
3 Enter this command:
./callp restart
Stopping the Call
Processor
To stop the Call Processor:
1 Log on to the machine hosting the Call Processor.
2 Navigate to the /opt/3com/VCX/callprocessor/bin directory.
3 Enter this command:
./callp stop
Verifying the Call
Processor State
There are two ways to verify whether or not the Call Processor is running.
This can be done either through EMS or from a command prompt on the
machine hosting the Call Processor.
Through EMS
To verify the state of the Call Processor using EMS:
1 Login to EMS.
2 Navigate to the Call Processor.
3 The status indicator light that appears next to the 3COM Sip Call
Processor identifies these states: