Filter
Top Products
222 APPENDIX A: CALL PROCESSOR COMMAND LINE INTERFACE COMMANDS
CLI Command Descriptions
The remote CLI application uses the following commands for
administering the Call Processor:
Table 39 Remote CLI Command Descriptions
Command Description
exit Quits the Remote CLI application.
shutdown Shuts down the Call Processor gracefully.
version Shows the software version of the Call Processor and the version of
the Distributed Message Routing (DMR) 3Com proprietary protocol.
show Lists all of the Call Processor tables that are used for configuration.
Con be used to determine all of the commands for each
configurable.
config Lists all of the configurable tables.
diagnostic Allows a user to make run-time only modifications to log levels.
exec Causes a plugin to execute a plugin specific command. To display
available commands for a plugin, issue the name of one of the
plugins listed from the plugin CLI command along with the execute
command.
statistics Displays various types of counters for a particular plugin. To display
available statistics for a plugin, issue the name of one of the plugins
listed from the plugin CLI command along with the statistics
command.
send Sends a message to a plugin.
dump Configures a plugin to display troubleshooting information.
messageTrace Turns on logging for all DMR messages within the Call Processor.
Note: Massage Tracing should only be used for short time intervals
since it affects the Call Processor’s performance due to unnecessary
overhead.
help Lists all of the possible commands that can be used, which are listed
in this table.
plugins Lists all of the plugin modules installed for the Call Processor.