Filter
Top Products
Back-end Server Maintenance 217
First, use Enterprise Management Suite to tell the 3Com VCX IP
Telephony Server where to send traps. Then use Enterprise
Management Suite to enable the traps. Finally, start the trap
generation.
Configuring Trap Destinations
To configure a trap destination using EMS:
1 From the Enterprise Management Suite Explorer tab, select 3Com VCX IP
Telephony Server to configure.
2 From the Properties tab, select Trap Destinations.
3 At the bottom of the right-hand pane, click Add.
The Add Row to Table dialog box opens.
4 Type the IP address and Community string for the trap destination.
5 Click OK.
The Trap Destinations tab changes to show the new trap destination.
Enabling Back-end Server Traps
The 3Com VCX IP Telephony Server can generate traps when the
authentication server changes state.
To enable back-end server traps using EMS:
1 From the EMS Explorer tab, click 3Com VCX IP Telephony Server to
configure.
2 Select the 3COM SNMP Agent element.
3 From the Properties tab, select Trap Configurations.
Figure 60
shows the location for all back-end server traps.