3Com V7000 Telephone User Manual


 
Configuration Files 331
Sample Media Gateway Configuration File (continued)
GWREGISTRATIONNAME = 'VCX-V6000'
Specify the user name that is included in From and To headers of Register
messages. This parameter applies only if AuthenticationMode is enabled
(set to 1). The default value is an empty string. If you do not change the
default value, the parameter Username is used in place of
GWREGISTRATIONNAME.
HOTLINETONEDURATION = 5
Set this parameter to control how long to wait, in seconds, for the user to
dial some digits before making a call to a preconfigured number. Possible
values range from 0 (zero) to 60 seconds. The default value is 5 seconds.
ENABLETRANSFER = 1
Enable (1) or disable (0, default) the ability of a user to transfer a call from
an analog telephone by using a hook flash. NOTE: The equipment at both
ends of the call must support this feature and the parameter
“EnableHold” must be enabled (set to 1).
WAITFORDIALTIME = 0
For outgoing FXO calls, specify a delay time, in milliseconds, between the
time that the line is seized and dialing starts. The default value is 1000
msec.
CODERNAME = g711Ulaw64k,20
CODERNAME = g729,20
CODERNAME_1 = g711Ulaw64k,20
CODERNAME_1 = g729,20
CODERNAME_2 = g729,20
CODERNAME_2 = g711Ulaw64k,20
Enter the names and packetization times for each CODEC that you use.
Possible CODEC names are:
g711Alaw64k — G.711 A-law
g711Ulaw64k — G.711
μ
-law
g7231 — G.723.1 6.3 kbps (default)
g7231r53 — G.723.1 5.3 kbps
g726 — G.726 ADPCM 32 kbps (Payload Type = 35)
g729 — G.729A