Filter
Top Products
Configuration Files 319
Sample Media Gateway Configuration File
;**************
;** Ini File **
;**************
Typically, an INI file is produced by exporting the file from a working
V6000 Media Gateway. This sample file corresponds to the default file
shipped with a V6000 Media Gateway. The export process records several
system parameters as comment lines at the beginning of the INI file.
Modify these comment lines when you create INI files for other V6000
Media Gateways so that the files reflect the parameters of the target unit.
;Board: Mediant 1000
;Serial Number: 328268
;Slot Number: 1
;Software Version: 4.60A.022.003
;Board IP Address: 10.230.64.100
;Board Subnet Mask: 255.255.255.0
;Board Default Gateway: 10.230.64.254
;Ram size: 64M Flash size: 16M
;Num DSPs: 2 Num DSP channels: 8
;Profile: NONE
;------------------------------
;To support LAN port redundancy
MIIREDUNDANCYENABLE = 1
To enable the second of the two LAN ports to act as a failover port for the
other, set MIIREDUNDANCYENABLE to 1.
BaseUDPport = 6000
Verify that the the UDP port number is set to 6000.
DisableSNMP = 0
Set DisableSNMP to 1 if you do not want to send SNMP trap information
from the V6000 to any SNMP management station(s). If you set it to 0,
you can then specify up to 5 management stations. For each station that
you want to specify, set the SNMPManagerIsUsed value to 1 and enter
the IP address on the corresponding SNMPManagerTableIP line.
SNMPManagerIsUsed_0 = 1
SNMPManagerIsUsed_1 = 0
SNMPManagerIsUsed_2 = 0
SNMPManagerIsUsed_3 = 0
SNMPManagerIsUsed_4 = 0
SNMPManagerTableIP_0 = 10.230.64.25