Filter
Top Products
47
Sample Network Configuration Script — Secondary Server (continued)
--------------------- Configuring IP Interface 'eth1' ---------------------
Interface State : enabled
Change the default value (disabled) to enabled.
IP Address :
Network Subnet Mask :
Default Gateway Address :
Enter the IP address for this server’s eth1 interface and the subnet mask
and default gateway address appropriate for this site.
------------------------- Configuring DNS Servers -------------------------
Enter DNS servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary DNS Server :
Secondary DNS Server :
Tertiary DNS Server :
Enter up to three DNS server IP addresses.
----------------------- Configuring DNS Search Path -----------------------
Press Enter to leave the current path unchanged, or specify
a new search path, with spaces separating each entry.
DNS Search Path :
Enter the DNS search path appropriate for this site.
-------------------- Configuring Network Time Protocol --------------------
Enter NTP servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary NTP Server :
Secondary NTP Server :
Enter one or two NTP server IP addresses.
CAUTION: If VCX systems are not synchronized via NTP, timing-related
problems can occur.
-------------------------- Configuring Time Zone --------------------------
Please select a geographic location from the following list:
1. Africa
2. Americas
3. Antarctica
4. Arctic Ocean
5. Asia