Filter
Top Products
46 CHAPTER 2: INSTALLING AN IP TELEPHONY AND MESSAGING SERVER
Configuring a Secondary IP Telephony and Messaging Server
To begin the configuration process, enter this command:
vcx-setup
The configuration script starts. The first portion deals with network
configuration.
Sample Network Configuration Script — Secondary VCX Server
---------------------------------------------------------------------------
-------------------- VCX Network Configuration Utility --------------------
---------------------------------------------------------------------------
This wizard sets up networking and related services.
Configure networking now? [yes] :
Press the Enter or Return key to accept the suggested answer (yes).
--------- Configuring Dynamic Host Configuration Protocol (DHCP) ----------
VCX servers can use DHCP for automated configuration, but this requires
that the DHCP server is configured to provide the proper options. Unless
you know that your environment is set up in this way, you should say 'no'
here and configure static network parameters.
Use DHCP on eth0 to configure network parameters? [yes] : no
Enter no to specify the IP addresses manually.
-------------------------- Configuring Hostname ---------------------------
Enter system hostname :
Enter the unqualified name that you want to use for this primary server.
Unqualified host names must conform to the rules outlined in “
Host
Names” in Chapter 2.
--------------------- Configuring IP Interface 'eth0' ---------------------
IP Address :
Network Subnet Mask :
Default Gateway Address :
Enter the IP address for this server’s eth0 interface and the subnet mask
and default gateway IP address appropriate for this site.