3Com V7000 Telephone User Manual


 
100 CHAPTER 3: INSTALLING AN IP TELEPHONY SERVER
Configuring an IP Telephony Server at a Branch Office
To begin the configuration process, enter this command:
vcx-setup
The configuration script starts. The first portion deals with network
configuration.
Sample Network Configuration Script — Branch Office IP Telephony Server
---------------------------------------------------------------------------
-------------------- VCX Network Configuration Utility --------------------
---------------------------------------------------------------------------
This wizard sets up networking and related services.
Configure networking now? [yes] :
Press the Enter or Return key to accept the suggested answer (yes).
--------- Configuring Dynamic Host Configuration Protocol (DHCP) ----------
VCX servers can use DHCP for automated configuration, but this requires
that the DHCP server is configured to provide the proper options. Unless
you know that your environment is set up in this way, you should say 'no'
here and configure static network parameters.
Use DHCP on eth0 to configure network parameters? [yes] : no
Enter no to specify the IP addresses manually.
-------------------------- Configuring Hostname ---------------------------
Enter system hostname :
--------------------- Configuring IP Interface 'eth0' ---------------------
IP Address :
Network Subnet Mask :
Default Gateway Address :
--------------------- Configuring IP Interface 'eth1' ---------------------
Interface State : disabled
IP Address :
Network Subnet Mask :
Default Gateway Address :
Branch office servers have only one network interface (eth0) enabled.
Enter no information for IP Address, Subnet Mask, or Default Gateway
Address.