3Com V7000 Telephone User Manual


 
139
Configuring a Branch Office IP Messaging Server
To begin the configuration process, enter this command:
vcx-setup
The network configuration portion of the script starts.
Sample Network Configuration Script — Branch Office IP Messaging Server
---------------------------------------------------------------------------
------------- Welcome to the VCX Network Configuration Wizard -------------
---------------------------------------------------------------------------
This wizard sets up networking and related services.
Configure networking now? [yes] :
Press the Enter or Return key to accept the suggested answer (yes).
--------- Configuring Dynamic Host Configuration Protocol (DHCP) ----------
VCX servers can use DHCP for automated configuration, but this requires
that the DHCP server is configured to provide the proper options. Unless
you know that your environment is set up in this way, you should say 'no'
here and configure static network parameters.
Use DHCP on eth0 to configure network parameters? [yes] : no
IP addresses for VCX servers must be static addresses. Enter no to
configure the network parameters for eth0 manually.
-------------------------- Configuring Hostname ---------------------------
Enter system hostname :
Enter the name that you want to use for this branch office server.
Unqualified host names must conform to the rules outlined in
Host
Names” in Chapter 1.
--------------------- Configuring IP Interface 'eth0' ---------------------
IP Address :
Network Subnet Mask :
Default Gateway Address :
Enter an IP Address, Network Subnet Mask, and Default Gateway
Address that are appropriate for this branch office.