Filter
Top Products
192 CHAPTER 6: INSTALLING A CALL RECORDS SERVER
Sample Services Configuration Script — Call Records Server (continued)
Enter 2 to configure this server for Call Records Services. The script warns
you that the choice cannot be reversed and gives you the opportunity to
change your choice.
You have chosen to configure this system to provide:
Call Records Service
Note that in order for these services to work, you must have purchased an
appropriate license and installed the corresponding license activation key
on this system.
*** WARNING *** Once you confirm your selection, you cannot change it.
Are you absolutely certain that you wish to configure this system as an
'Call Records Service' server?If you answer 'no' here you can choose an
alternative configuration.
Confirm selection? [no] : yes
Enter yes to confirm your choice.
Selection confirmed.
The script prints several configuration messages.
----------------------------------------------------------------------------
------------- Welcome to the VCX Service Configuration Wizard -------------
----------------------------------------------------------------------------
This wizard sets up VCX services.
Do you wish to configure services at this time? [Y] :
Press the Enter or Return key to accept the suggested answer (Y).
------------------------- Configuring VCX Services -------------------------
This server runs the Call Records Service.
Services running on this server need to communicate with other servers and
devices in order to operate. In the next series of questions, you will be
asked for information about these external services and devices, and for
other global parameters.
The Call Records Service consolidates call accounting records for the VCX
system. It is only enabled on one server for an entire installation.