3Com V7000 Telephone User Manual


 
188 CHAPTER 6: INSTALLING A CALL RECORDS SERVER
Sample Network Configuration Script — Call Records Server (continued)
Configure networking now? [yes] :
Press the Enter or Return key to accept the suggested answer (yes).
--------- Configuring Dynamic Host Configuration Protocol (DHCP) ----------
VCX servers can use DHCP for automated configuration, but this requires
that the DHCP server is configured to provide the proper options. Unless
you know that your environment is set up in this way, you should say 'no'
here and configure static network parameters.
Use DHCP on eth0 to configure network parameters? [yes] : no
Enter no to specify the IP addresses manually.
-------------------------- Configuring Hostname ---------------------------
Enter system hostname :
Enter the unqualified name that you want to use for this primary server.
Unqualified host names must conform to the rules outlined in
Host
Names” in Chapter 6.
--------------------- Configuring IP Interface 'eth0' ---------------------
IP Address :
Network Subnet Mask :
Default Gateway Address :
Enter the IP address for this server’s eth0 interface and the subnet mask
and default gateway IP address appropriate for this site.
--------------------- Configuring IP Interface 'eth1' ---------------------
Interface State : enabled
Change the default value (disabled) to enabled.
IP Address :
Network Subnet Mask :
Default Gateway Address :
Enter the IP address for this server’s eth1 interface and the subnet mask
and default gateway address appropriate for this site.
------------------------- Configuring DNS Servers -------------------------
Enter DNS servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary DNS Server :
Secondary DNS Server :
Tertiary DNS Server :
Enter up to three DNS server IP addresses.