3Com V7000 Telephone User Manual


 
328 APPENDIX B: AUTOMATED BRANCH OFFICE INSTALLATION
Sample Media Gateway Configuration File (continued)
USERNAME = 'VCX-V6000'
Enter VCX-V6000 as the user name to be used for registration and
authentication. NOTE: This parameter is used only if the Authentication
Mode is “Authentication Per Gateway.”
DEFAULTRELEASECAUSE = 34
When an outgoing call over an FXO line is released by the gateway, a
cause is associated with the release. Specify a cause that will be used if no
other release cause can be found. Possible values are:
3 — NO_ROUTE_TO_DESTINATION
34 — NO_CIRCUIT_AVAILABLE
27 — DESTINATION_OUT_OF_ORDER
PROGRESSINDICATOR2IP = 0
Select the type of progress indicator that you want the gateway to send.
Possible values are:
0 — The gateway sends “180 Ringing” for calls placed to FXS
endpoints or to a PBX over an FXO line.
1 — The gateway sends “183 Session in Progress” if the
EnableEarlyMedia parameter is enabled (set to 1).
8 — Same as 1.
-1 — Not configured. Default values are used.
The choice Depending on the value of EnableEarlyMedia, the gateway
should send one of these progress indicators
ISFALLBACKUSED = 1
Enable (1) or disable (0) the ability of the gateway to use the internal “Tel
to IP” routing table whenever it cannot contact a Proxy. When the
gateway finds a Proxy, it switches from using the internal routing table to
using proxy routing again.
ISPROXYHOTSWAP = 1
Enable (1) or disable (0) the ability of the gateway to send SIP INVITE
messages to a secondary SIP Proxy if the primary proxy does not respond
after the configured number of retries.
PROXYREDUNDANCYMODE = 1
Enable (1) or disable (0) the gateway to always try to work with the
primary Proxy. If this parameter is set to 0 and the primary proxy fails, the