Filter
Top Products
Adding Trusted Endpoints 287
■ row=3: Sets the state of the row to NOT_READY. Use this value
only when a row already exists. There is no need to respecify the
trustedaddr and netmask values.
■ row=4: Creates the row and sets the state to ACTIVE
■ row=5: Creates the row and sets the state to NOT_READY
■ row=6: Deletes the specified row
■ index — This element of the command specifies the row number to
which the action specified by
row will be applied. When adding a new
trusted endpoint, always use an index number that is one greater than
the last index number shown in the output of the
show cctrusted
command.
■ trustedaddr — The IP address of the trusted endpoint
■ netmask — Always use 255.255.255.255 as the netmask when
adding a single endpoint. Any other value specifies a range of IP
addresses using the Variable Length Subnet Mask (VLSM) method.
To verify that the trusted endpoint has been added to the list, enter this
command:
show cctrusted
Sample output from the show cctrusted command after a new row
(with index=5) has been added:
CcTrusted
-Index -RowStatus -TrustedAddress -Netmask
1 1 10.230.64.5 255.255.255.255
2 1 10.230.63.7 255.255.255.255
3 1 10.230.63.15 255.255.255.255
4 1 255.255.255.255
5 1 10.230.64.7 255.255.255.255