Filter
Top Products
Replacing a Disk (Single Site) 383
f Switch to the more recent version of the operating system using this
command:
vcx-os-switch 3.3.1
4 Reboot the down server using this command:
reboot
5 After the reboot process has been completed, configure VCX services on
the down server using this command:
vcx-setup
The script detects that you have already configured the networking
parameters for the server and prompts you to configure VCX services.
If the down server is the Primary IP Telephony Server, follow the
instructions in
“Configuring a Primary IP Telephony Server (Single Site)” in
Chapter 3.
If the down server is the Secondary IP Telephony Server, follow the
instructions in
“Configuring a Secondary IP Telephony Server (Single
Site)” in Chapter 3.
If the down server is the Primary IP Messaging Server, follow the
instructions in
“Configuring a Primary IP Messaging Server” in Chapter 4.
If the down server is the Secondary IP Messaging Server, follow the
instructions in
“Configuring a Secondary IP Messaging Server” in
Chapter 4.
After VCX Services have been configured, this message appears.
Please wait while the wizard completes.
The script displays several status messages and exits.
Completing the Disk Replacement Process
If the replacement disk is installed on a Primary or Secondary IP
Messaging Server, see
“Restoring an IP Messaging Server to Service” later
in this section. If the replacement disk is installed on a Primary or
Secondary IP Telephony Server, see
“Restoring an IP Telephony Server to
Service” next.