3Com V7000 Telephone User Manual


 
Attendant Console Installation 247
4 Connect a 3Com power adapter to an AC power outlet.
5 Connect the other end of the power adapter cable to the power
connector on the underside of the 3105 Attendant Console.
6 Use a terminal emulation program such as Hyperterm to connect to the
serial port on your PC. The configuration is:
9600 baud
8 data bits
1 stop bit
No parity
No flow control
7 In the Hyperterm window, enter this command to set the IP address of
the Primary VCX Server:
nbxSetNcpIpAddress 10.20.30.41
All IP addresses and subnetwork masks used here are examples only. You
must use values appropriate for your network.
8 Enter this command to set the IP address of the Secondary VCX Server:
vcxSetAltCallPIP 10.20.30.42
9 Enter this command to set the dialing domain for the Attendant Console:
vcxSetDialDomain 1.1.1.1
10 If a DHCP server does not provide IP addresses on your network, enter
these commands:
To assign an IP address that you select to the Attendant Console:
nbxSetIpAddress 192.168.10.101
To define the subnetwork mask for this subnetwork:
nbxSetSubnetMask 255.255.255.0
To define the IP address for the gateway on this subnetwork:
nbxSetGatewayAddress 192.168.10.254
To verify the current settings use the vcxShowConfig command.
11 Enter this command to restart the Attendant Console:
nbxReset
The Attendant Console communicates with the Primary VCX Server. Use
the Administrator Interface to: