3Com V7000 Telephone User Manual


 
272 CHAPTER 11: MAINTENANCE
Sample VCX Reconfiguration Script
---------------------------------------------------------------------------
--------------- Welcome to the VCX Reconfiguration Utility ----------------
---------------------------------------------------------------------------
This utility allows a previously configured VCX system to be reconfigured -
for example, to change its IP address or the IP addresses of other VCX
servers with which it communicates.
To accomplish this, it is necessary to carry out several steps including
stopping VCX services and discontinuing any replication which may be
occurring with other servers. Therefore, this utility should only be run
on a system which is not in active use.
Sample VCX Reconfiguration Script (continued)
Following reconfiguration, you must follow the VCX documentation to bring
all servers back online and re-establish any replication which was in use.
The correct procedures must be followed for this process to succeed.
Do you wish to reconfigure the system at this time? [no] : yes
Starting reconfiguration.
---------------------- Preparing For Reconfiguration ----------------------
VCX services are currently running - stopping them now.
Stopping VCX Services:
Stopping vcx/devdnldsvr: [ OK ]
Stopping vcx/callp: [ OK ]
Stopping vcx/tomcat: [ OK ]
Stopping vcx/ums: [ OK ]
Stopping vcx/bssxml: [ OK ]
Stopping vcx/acctxml: [ OK ]
Stopping vcx/vcxglobaldir: [ OK ]
Stopping vcx/vcxdata: [ OK ]
Stopped VCX Services: 8 stopped.
Replication is in use.
Dropping replication - please wait.
Copyright (C) 2005 3COM Corporation. All rights reserved.
3Com VCX Multi-Master Replication DROP Start Configuring ....