3Com V7000 Telephone User Manual


 
Item Description
1 Locking screw
2 Status light (Ethernet activity)
3 10/100 Ethernet port
4 Status light (Ethernet link status)
5 Status light (general purpose)
6 RJ-11 connector used for night bell relay output
7 Status light (disk 1)
8 Status light (disk 0)
9 Reset button access (button is located behind the front panel)
10 CPU run status light
11 RJ-11 connector (voice + PTT control) used for paging output
12 3.5 mm stereo mini jack connector used as an input for Music-on-Hold
13 Locking Screw
Gateway Installation 253
Configuring the Media Gateway Network Parameters
To connect the V6000 to the Public Switched Telephone Network (PSTN),
analog telephones, fax machines, and your company’s data network,
follow the instructions in this section.
1 Mount the V6000 in a 19-inch cabinet using the mounting brackets that
are supplied, or place the V6000 on a desktop.
2 Connect the Media Gateways portion of the V6000.
a Connect an Ethernet cable (RJ-45 connector) to the Ethernet
connector that is located on the CPU module on the front panel.
b Connect the other end of the Ethernet cable to your network.
c The V6000 may have one or two power supplies. Connect one or
both supplies to a power source using the power cables supplied with
the unit.
d Verify that, after a self-test period of approximately two minutes, the
status light (LED) on the front panel of the power supply turns green.
3 Assign an IP address to the Media Gateways portion of the V6000.
a Disconnect the Ethernet cable from the Ethernet connector that is
located on the CPU module on the front panel.
b Connect a crossover Ethernet cable to the Ethernet port on a PC that
is not connected to your network.