3Com V7000 Telephone User Manual


 
322 APPENDIX B: AUTOMATED BRANCH OFFICE INSTALLATION
Sample Media Gateway Configuration File (continued)
V22ModemTransportType = 0
V23ModemTransportType = 0
V32ModemTransportType = 0
V34ModemTransportType = 0
Specify the transport type for these modems. Possible values are:
0 — Transparent
1 — Relay
2 — Bypass
NOTE: V32ModemTransportType applies to V.32 and V.32bis modems.
NOTE: V34 ModemTransportType applies to V.34 and V.90 modems.
FaxRelayRedundancyDepth = 2
Specify the number of times that each fax relay payload is retransmitted
to the network. Possible values are 0 (default), 1, and 2.
FaxModemBypassCoderType = 1
Specify the type of coder to be used when performing fax modem
bypass. Possible values are:
0 — G711 A-law 64 (default)
1 — G711
μ
-law
4 — G726 32
11 — G726 40
BasicRTPPacketInterval = 3
Set this parameter using the web browser interface. Navigate to Protocol
Definition > Coders and set the value there. The value that you select
appears in the INI file when the file is exported.
CNGDetectorMode = 2
Set this value to determine whether you want fax sessions to start when
the fax calling tones are detected. Possible values are:
0 — Don’t detect fax calling tones (default)
1 — Not applicable
2 — Detect fax calling tones and start the fax session.