3Com V7000 Telephone User Manual


 
326 APPENDIX B: AUTOMATED BRANCH OFFICE INSTALLATION
Sample Media Gateway Configuration File (continued)
CDRREPORTLEVEL = 2
Determine the amount of Call Detail Record inforamation that is sent to
the Syslog Server. Possible values are:
0 — No information is sent (default).
1— Information is sent at the end of each call.
2 — Information is sent at the beginning and at the end of each call.
CHANNELSELECTMODE = 1
Select the mode by which channels are selected for outgoing calls.
Possible values are:
0By phone number: Select the gateway port according to the
number that is being called. This mode requires an Endpoint Phone
Number table. This is the default mode.
1Cyclic Ascending: Select the next available channel in an
ascending cycle order. Always select the next higher channel number
in the hunt group. When the gateway reaches the highest channel
number in the hunt group, it selects the lowest channel number in the
hunt group and then starts ascending again.
2Ascending: Select the lowest available channel. Always start at
the lowest channel number in the hunt group and if that channel is
not available, select the next higher channel.
3Cyclic Descending: Select the next available channel in
descending cycle order. Always select the next lower channel number
in the hunt group. When the gateway reaches the lowest channel
number in the hunt group, it selects the highest channel number in
the hunt group and then starts descending again.
4Descending: Select the highest available channel. Always start at
the highest channel number in the hunt group and if that channel is
not available, select the next lower channel.
5Number + Cyclic Ascending: First select the gateway port
according to the called number that is being called. (This mode
requires an Endpoint Phone Number table). If the called number isn't
found, then select the next available channel in ascending cyclic order.
NOTE: If the called number is found, but the port associated with this
number is busy, the call is released.