AT&T 3.0 Telephone User Manual


 
Backing Up with a Memory Card
CAUTION:
The memory card may be write-protected to avoid the accidental
erasure of the backup files. Make certain this is not the case before
you change the write-protect tab.
Card Failure
Memory Card Backup:
Backup Failure
Try a different file or
a new Memory Card.
Exit
If the card is damaged, repeat the backup with a different card. If a
backup is in progress and fails, the system makes two additional attempts
at the backup. At the start of each attempt, a message appears with the
percentage of the backup that is completed. lf the backup fails after three
attempts, the screen shown above appears. Repeat the backup procedure
using a different file and/or memory card.
Restore
Use this procedure to restore system conditions that were backed up onto
a translation memory card. The information in a backup file on the
translation card is copied to the system.
The restore procedure is necessary under the following conditions:
System RAM is corrupt.
A previously stored set of system conditions is preferred over the
current set.
The processor module is replaced.
After a System Erase (frigid start) has been performed.
The system software has been reinstalled.
D–18 Maintenance and Troubleshooting