AT&T 3.0 Telephone User Manual


 
Error Logs
Table 2-2
Continued
Error
Codes Description
Action
8405
ON HOOK BEFORE READY:
Troubleshoot the far end of the network
Outbound dialing problems on tie
interface to see whether it is working and
trunks. For a tie trunk with delay dial translated properly. Troubleshoot for wink
or wink start, the far end of the
start and faulty cable. Troubleshoot the
network interface went on-hook
far end of the network. Replace the
before the guard time elapsed.
module.
8406
INTERDIGIT TOO SHORT:
Troubleshoot the far end of the
Inbound dialing problems on tie and
network interface to see if it is working
DID trunks. and translated properly. Troubleshoot
for faulty cable. Replace the module.
8407
BAD UPDATE:
Turn the processor off and then on.
communication problems occurred
Repeat system programming procedure.
between the processor and the
[f problem persists, escalate to your
modules. Module may need to be
technical support organization.
replaced.
8408
ROTARY RATE > 12PPS:
Troubleshoot the far end of the
Inbound dialing problems on tie and
network interface to see if it is working
DID trunks.
and translated properly. Troubleshoot
for faulty cable. Replace the module.
8409
ROTARY RATE < 8PPS:
Troubleshoot the far end of the
Inbound dialing problems on tie and
network interface to see if it is working
DID trunks.
and translated properly. Troubleshoot
for faulty cable. Replace the module.
840A
BAD DOWNLINK MESSAGE:
Turn the processor off and then on.
Communication problems occurred
Repeat system programming
between the processor and the
procedure. If the problem persists,
modules, The module received an replace the module.
unrecognized message from the
processor.
Continued on next page
2-16 Error Logs, Access Logs, and System Inventory