Filter
Top Products
Checking Ports
This indicates that the problem may beat the central office (CO) end.
First, make sure the correct B-channel is selected. If the correct B-channel is
selected, the customer or AT&T representative acting as the customer’s agent
should ask the CO to clear the problem from that end. If the problem is not at
the CO end, select the correct B-channel and repeat the Audit Lines
procedure.
Auditing Calls
Summary
Console Procedure
PC Procedure
Appropriate Slot or
Port
Time Estimate
Backup Procedure
Busy-Out or Reset
Interrupting the Test
Restore
To audit calls, follow the
Menu
→
Maintenance
→
Port
→
B-Channel
→
Dial the
slot and port no.
→
Enter
→
Audit Call
(F6)
→
(F3)
→
(F7)
→
Type the slot and port no.
→
(F10)
→
(F2)
This test can be run only on the slot and port of a
DS1 PRI B-channel.
Four minutes
Not required
Not required
You cannot interrupt this test.
Not required
steps below.
Console Display/Instructions
Additional Information
PC
1 From the Maintenance Menu, select the Port option.
Maintenance
Make a selection
System
Slot
Port
Exit
(F3)
5–28 Central Office Problems