AT&T 3.0 Telephone User Manual


 
Module Problems
Busy-Out or Reset
Busy-out or reset the module being tested prior to
beginning the test. Both Busy-Out and Reset are in
the Slot menu, which you can access by doing the
following from the console:
Menu
Maintenance
Slot
See “Busy-Out and Reset,” earlier in this chapter,
for additional information.
Interrupting the Test
You can interrupt the test (both
Test Once
and
Repetitive)
by selecting
Exit.
Test Failure
If the test fails, record the errors on the repair tag
and replace the module.
Restore
Restore the module if it successfully completes all
module tests and the errors no longer occur.
Restore
is in the Slot menu, which you can access
by doing the following from the console:
Menu
Maintenance
Slot
See the “Restore” procedure, earlier in this chapter,
for additional information.
To run the Internal Loopback Module Test, follow the steps below.
Console Display/Instructions
Additional Information
PC
1 From the Maintenance menu, select the Slot option.
Maintenance
Make a selection
System
Slot
Port
Exit
(F2)
4-46 Control Unit Problems