Filter
Top Products
Installing the Basic Carrier
1
2
3
4
5
To install the basic carrier, follow the steps below:
Mark the screw-hole locations on the backboard, using the basic carrier
or the template supplied with the plastic preassembled backboard as a
guide. See Figure 2-5.
Make sure the carrier is level before marking the holes.
Drill a pilot hole in the center of each of the four screw-hole marks.
Anchor the screws approximately halfway into the backboard.
Position the carrier on the screws and slide the carrier to the left.
Tighten the screws.
Mounting Surface
Mounting ‘\ ‘
Screw \
\
Backboard
Basic
Carrier
Figure 2-5. Marking the Basic Carrier Screw Holes
2-18 Installing the Control Unit