System Programming and Maintenance (SPM)
Hardware Requirements
The following hardware is required:
■
An approved PC or other DOS-compatible PC with:
— At least 512K of RAM
— A double-sided floppy disk drive (either 5.25-inch or 3.5-inch)
— A serial port assigned to COM1 or COM2. The serial port can use
either a DB-9 or DB-25 connector. If a DB-9 connector is used, a
9-pin to 25-pin adapter is also required. The 9-pin side must be
female.
■
Video monitor (monochrome or color)
■
D8W cord and 355AF adapter if the PC is within 50 ft. (l5.2 m) of the
control unit. Distances of greater than 50 ft. (15.2 m) require back-to-
back ADUs.
See System Programming and Maintenance (SPM) for installation instructions.
Installing Applications 8-25