AT&T 3.0 Telephone User Manual


 
Error Logs
Table 2-2
Continued
Error
Codes Description
Action
1C03
FW UPGRADE COMPLETE
No action required.
3001
ALARM TABLE FULL:
Correct indicated errors, and then
The error logs are full, and no more
remove entries from the transient system
errors can be added to them.
error log to free up space. If problem
Turns on the processor LED.
persists, cold-start the system before
continuing with troubleshooting.
Sys Program
System-Restart
4401
USER REQUESTED SYS ERASE:
If this error remains in the transient log,
This error is logged after a System
do the System Erase again. If problem
Erase. If the System Erase is
persists, troubleshoot the processor.
successful, this error is removed
immediately.
6C01 DS1 LOSS OF SIGNAL ALARM:
Troubleshoot the T1 trunk. If problem
Service on the link has been lost.
persists, check the channel service unit
(CSU) and the cable between the CSU
and the 100D module. If problem
persists, escalate to your technical
support organization.
6C02
DS1 BLUE ALARM:
All ones being received
the link has been lost.
The far end of the network interface is out
Service on of service. Troubleshoot the T1 trunk,
channel service unit (CSU), and the
cable between the CSU and the 10OD
module. If problem persists, escalate to
your technical support organization.
6C03
DS1 RED ALARM:
Troubleshoot the T1 trunk. If problem
Incoming signal does not have valid
persists, escalate to your technical
framing information.
support organization.
Service on the link has been lost.
Continued on next page
Error Logs, Access Logs, and System Inventory 2-9