Filter
Top Products
Assembling MLX Telephones
See
Figure 3–36. Replacing the Extension Label
plastic cover.
Replace the extension
label and
6
7
a Insert one end into the slot and snap the other
3-36.
b If you are mounting an MLX-10, MLX-10D, or MLX-10DP wall telephone, go
to Step 7. If you are assembling a desk telephone, go to Step 8.
end into
place.
Figure
Wall mounting an MLX-10, MIX-10DP, or MlX-10D telephone.
a Turn over the telephone and remove the jack guard from the TEL/OTHER
jack area; set the telephone aside.
Unpack the 630B Phonemount and remove the modular jack from the
b
backplate.
Route the D8W cord (or DIW cable) through the hole in the
have it exit at the top of the backplate; leave 10 in. (25 cm)
connect the telephone. See Figure 3–37.
backplate and
of cord to
c
3-54 Installing Telephones and Adjuncts