AT&T 3.0 Telephone User Manual


 
Error Logs
Table 2-2
Continued
Error
Codes Description
Action
0009
FRIGID START:
If the processor was removed while in
System was restarted and initialized use, the system may perform a frigid start
to default programming.
This error is also logged
System Erase.
due to loss of system programming.
after a
Restore system as described in System
Programming and Maintenance (SPM),
or
in Appendix D, "Backing up with a
Memory Card”.
000A
POWER UP COLD START:
If problem persists, troubleshoot the
A RAM failure was detected in the
processor.
processor.
System programming is okay.
000B
CARD INSERTED/REMOVED:
No action required.
000C
SLOT STREAM CNT EXCEEDED:
If problem persists, troubleshoot the
Slot has generated excessive
module.
interrupts.
000D
FMWR NOT IN STANDBY MODE:
If problem persists, troubleshoot the
Module firmware is not in standby
module.
mode.
000E
COMMAND BUFFER FULL:
If problem persists, troubleshoot the
processor and module.
000F
TASK RUNNING TOO LONG:
No action required: however, if problem
persists, troubleshoot the processor.
0010
INVALID SLOT INTERRUPT:
Troubleshoot modules and replace if
Cannot determine module responsible necessary. If problem persists.
for generating the interrupt.
troubleshoot the processor.
0011
STACK OVERFLOW:
Troubleshoot the processor.
Processor problem
Continued on next page
Error Logs, Access Logs, and System Inventory 2-7