AT&T 3.0 Telephone User Manual


 
Call Accounting System
CAS software
To use CAS for Windows with the system, the following components are
recommended:
For a single-site system, an NCR 3315 PC (20-MHz 386) with 6 MB of
RAM and a 120-MB hard disk
For a multi-site system, an NCR 3332 PC (66-MHz 486) with 16 MB of
RAM and a 340-MB hard disk
MS-DOS 5.0 or higher
— Windows 3.1 or later
VGA color monitor
Bus mouse
For a single-site system, a 525-MB tape drive
For a multi-site system, a 120-MB tape drive
Okidata
®
Microline 184T dot matrix or OL830 laser parallel printer
For communications using CAS for Windows, the following components are
recommended:
For a single-site system, one parallel port and two built-in serial ports
(DB9 for direct switch connection and DB25 for other connections)
For a multi-site system, one parallel port and a four-port Equinox
Mark-lV board with four RJ45 connections for direct switch hookup
For remote diagnostics, a Remote Maintenance Board
If a modem is used, an AT&T COMSPHERE 3830 or compatible
If you are using the 9-pin port on your PC for the direct switch
connection, you need a DB9-to-modular adapter.
An RJ45 modular cable to connect the PC’s COM1 port with the
control unit’s SMDR port
8-6 Installing Applications