Filter
Top Products
System Management
■
■
■
■
If a message arrives at a subscriber’s mailbox after the specified
Outcalling time interval, Outcalling notification for that message is not
initiated at the next Outcalling time interval.
The system attempts to outcall three times within a minimum time interval
of 15 minutes between attempts. However, during heavy message traffic
periods the time interval may be longer.
For a pager/beeper number:
—
—
—
Subscribers can program a callback number as part of the Outcalling
number.
Subscribers are advised to enter several pauses (where each pause
is represented by a * sign) after the Outcalling number (before
entering their PIN and/or callback number) to allow the paging system
sufficient time to answer. Subscribers should experiment to determine
the correct number of pauses needed after the pager service number.
It is important to ensure that enough time is allowed for the call to be
dialed and answered before additional information (such as the PIN or
callback number) is dialed.
It is strongly recommended that subscribers verify that the system can
function properly with the Outcalling number as it is entered.
Subscribers should leave a message in their own mailbox during a
scheduled Outcalling period to ensure that the system places the call
to their beeper.
For a telephone number:
—
—
—
After the system has sent all the digits of the Outcalling number, the
system plays a message that announces the subscriber’s mailbox
number and notification that a new message has arrived. It also
instructs the subscriber how to access the new message and how to
cancel the Outcalling notification. This message is repeated five times
unless it is interrupted by the subscriber.
The subscriber may make up to three attempts to log in during the
outcall before the system disconnects.
A subscriber can cancel Outcalling for a new message without
logging in or listening to the new message by pressing [
★
] [
#
] when
listening to the Outcalling notification message.
5-4