Filter
Top Products
Initial Programming
Line Ownership
Before you begin, locate Form 6 for the voice messaging system.
■
If Form 6 is filled out, use the procedure below to assign ownership.
■
If Form 6 is not filled out, skip to “Communications System
Programming.”
Assigning Line Ownership
To assign an owner to an outside line as specified on Form 6:
1.
2.
3.
4.
5.
6.
7.
8.
If necessary, access the Programming Main Menu. If you are already at
the Programming Main Menu, skip to Step 2.
a.
Press [
Intercom
] [
7
] [
7
] [
7
] or the programmed VMMsgs button.
b.
Press [
9
] [
9
] [
#
].
c.
Enter the Mailbox Password and press [
# ].
d.
Press [
9
].
Press [
6
] for Line Ownership.
Press [
4
] to assign Line Ownership.
Enter a line number specified in Column A of Form 6, followed by [ # ].
Enter the line owner’s mailbox number specified in Column D of Form 6,
followed by [
# ].
Repeat Steps 4 and 5 for each owned line.
Hang up to exit voice messaging system programming.
Refer to the next section to program the communications system.
4-18