Filter
Top Products
Chapter 12 Installing the Companion system 175
Installation and Maintenance Guide
This procedure explains how to mount the RPI unit.
1 Partially screw in two #10 50 mm (2 in.) screws using the dimensions shown in Figure 60.
Figure 60 RPI mounting holes
2 Open the cover with a screwdriver.
a Use the screwdriver to push in, and then down, to release the latch on the right side.
b Remove the cover by lifting it up. Refer to Figure 61.
Figure 61 Opening the RPI cover
3 Hang the RPI on the two screws and tighten the screws.
4 Install the remaining two screws.
325 mm
(13 in.)
25 mm
(1 in.)
50 mm
(2 in.)
300 mm
(12 in.)
Keyholes