Filter
Top Products
136 Chapter 8 Installing media bay modules
P0993298 02
Replacing media bay modules
When media bay modules require replacement, follow the steps in this section.
Figure 46 Process map: Replacing a media bay module
If a media bay module fails, follow this procedure to properly replace the module.
1 Follow the steps in “Shutting down the system” on page 132 to ensure the system shuts down
correctly.
2 Remove the front bezel from the unit where the module resides.
3 Pull the latch beside the module to be replaced to release the module. Refer to Figure 44 on
page 133.
4 Slide the module out of the bay where it is installed.
5 Record the switch settings from the old module.
Warning: This section describes replacing a module with the same type of module. If you
want to replace a module with a different type of module, you must treat it as a new
installation. Refer to Chapter 7, “Setting media bay module DIP switches,” on page 115
and review Figure 41 on page 120 to ensure the new module does not overrun any lines
already assigned to other modules.
Module
failure
Disconnect cables
from the front of
the BCM1000 and
BCM1000e
Remove power
from both units
Remove front bezel
from BCM1000 or
BCM1000e
Remove failed
module
Set DIP switches
on new module to
match old module
Install new module
in media bay
Replace
coverplate
Restore power to
BCM1000 and
BCM1000e
Reconnect all
cables
Monitor LEDs for
power and status
Check the module
settings in the Unified
Manager