Filter
Top Products
Chapter 8 Installing media bay modules 133
Installation and Maintenance Guide
Installing a media bay module
After the system is powered down, you can install and remove media bay modules, as required.
Follow these procedures to install a media bay module. Reverse the procedure to remove modules.
1 Ensure that the switches on the media bay module are set correctly. For information about how
to set the switches, refer to Chapter 7, “Setting media bay module DIP switches,” on page 115.
In the case of FEM modules, the switches activate the front ports. Ensure that the switches
accurately reflect the ports you require. Refer to “FEM switch settings” on page 130.
2 Remove the front bezel from the unit where you want to install or remove the module by
grasping the edges and pulling forward. Refer to Figure 43.
Figure 43 Removing the front bezel
3 Select an open media bay.
4 Pull the latch beside the selected bay to release the media bay bezel. Refer to Figure 44.
Figure 44 Identifying the media bay module latches
BCM1000
Grasp the edge of the front bezel and pull
it forward
BCM1000e
1. Push against the bottom
2. Pull out from the top
media bay module latches
BCM1000
BCM1000e