Filter
Top Products
Chapter 9 Starting the system 153
Installation and Maintenance Guide
6 In the IP Address field, enter 10.10.10.2.
7 In the Subnet Mask field, enter
255.255.255.0.
8 Click OK.
9 Click OK.
10 Click Yes to restart the PC.
Connecting the Ethernet crossover cable
After you configure the computer, connect the computer to the BCM1000 in the following manner:
1 Shut down the computer.
2 Attach one end of the Ethernet crossover cable to the LAN card on the BCM1000.
3 Connect the other end of the cable to the network interface card on your computer.
4 Start the computer.
5 Log on to the Unified Manager using the default IP address.
6 Use the Quick Start Wizard to create the system configuration.
Refer to the Business Communications Manager Programming Operations Guide for details
about using the wizard. The Programming Operations Guide provides a detailed record about
the information that you require to configure basic system programming.
Entering the software keycodes
If you have purchased any of the optional Business Communications Manager applications that
require keycode activation, refer to Business Communications Manager Software Keycode
Installation Guide for information about how obtain the keycodes from the Nortel Networks
Keycode Retrieval System (KRS) and how to enter them into the Unified Manager. These codes
can be entered after basic system configuration is complete.
Regenerating keys after system replacement
If you need to replace your BCM1000, which would be the case if the motherboard or MSC
became inoperable, you will need to regenerate all your keycodes to reflect the new system
identification, and enter them again after you perform your system data restore.
Warning: If you change this information on an existing system, the telephony
programming is erased and the telephony system is disabled for a period of time. The
Business Communications Manager also performs a cold start.