Filter
Top Products
Appendix E: M3110, M3310, and M3820 telephones Page 485 of 504
Telephones and Consoles Description, Installation, and Operation
Procedure 85
Wall mounting the telephone
The procedure to wall mount the telephone by reversing the footstand is as
follows:
1 Unplug the line cord from the connecting block.
2 Remove the handset and place the telephone upside down on top of a
level, solid work surface covered with soft material or paper to prevent
damage to moveable keys and the telephone face.
3 Remove the 2 screws from the telephone footstand (if fitted) to separate
the footstand from the telephone.
4 Remove the wall-mount clip located inside the footstand and insert the
clip in the switchhook rest using the holes provided.
5 Rotate the footstand 180 degrees, snap the footstand back into place and
tighten the screws. Note that the footstand must be screwed to the base
for wall mounting.
6 Mount the telephone on the wall using the wall-mount holes provided on
the bottom of the footstand.
7 Plug the line cord connector back into the connecting block.
Note 1: The footstand cannot be reversed when the MCA data option or
key expansion module is equipped so such telephones cannot be wall
mounted.
Note 2: An additional clip is provided for wall mounting the telephone.
This clip is attached to the switchhook rest to prevent the handset from
slipping when mounted on the wall.
End of Procedure