Filter
Top Products
Appendix B: Meridian Modular Telephones installation Page 361 of 504
Telephones and Consoles Description, Installation, and Operation
Install an M2317 telephone
Follow the steps in Procedure 63 to install an M2317 telephone.
Procedure 63
Installing the M2317 telephone
1 Complete the wiring and cross-connection as shown in Figure 63 on
page 363 before connecting the telephone to the TELADAPT connector
block.
2 Place the telephone upside down on a number of sheets of soft, clean
paper and on a solid, level work surface to prevent damage to movable
keys and the telephone’s face.
3 Connect the handset cord 4-conductor TELADAPT connectors to the
handset and to the telephone and snap into place.
4 Turn the smooth side of the cord away from the telephone base and
secure it under the restraining tab. This ensures that the telephone sits
level after the installation is complete.
5 Connect the 6-conductor line cord to the telephone base, and place it
under the restraining tabs.
6 Turn the telephone face up, and place it in the normal operating position.
7 Print the Directory Number (DN) on the designation card and place it in
the designation card holder.
8 Designate button labels for programmable keys, and place them under
the button cover.
9 Insert the line cord TELADAPT connector block and snap it into place.
Place the line cord under the restraining tabs.
10 Plug the 5 V power supply connector into the back of the telephone.
11 Plug the power supply into an AC utility outlet.
12 After the M2317 digital telephone is connected to a line that is both
enabled and designated as an M2317 digital line, the startup screen
displays INITIALIZATION V6.4. Within 5 seconds, the Idle state screen is
displayed, and the M2317 is operational. The term V6.4 represents the
firmware issue number, and can differ with some installations.