Filter
Top Products
Page 192 of 504 M3900 installation and configuration
553-3001-367 Standard 3.00 August 2005
Installing the Accessory Connection Module
Use the Procedure 32 to install the Accessory Connection Module (ACM).
Procedure 32
Installing the ACM
1 Disconnect the line cord from the telephone base before installing the
ACM.
2 Slide the footstand down (using the plastic hinges) about 7 mm (1/4 in.)
and swing the footstand away from the telephone base.
3 Snap the ACM into the rectangular opening on the back of the telephone.
4 Connect the ACM cable to the back of the telephone.
5 Put the ACM attached ribbon cable into the track running down the back
of the telephone base.
6 Put the hard plastic cable cover over the ACM ribbon cable.
7 Snap the ACM plastic cable cover into place.
8 Place the footstand on the hinges.
9 Swing the footstand back into place.
10 Snap the footstand into a non-movable position.
11 Reconnect the line cord to the telephone base.
12 Return the telephone to an upright position.
There is a cutout on the base of the footstand which displays the ACM
connector ports. When ready to attach an accessory, insert the appropriate
cartridge into the port slot. There is one accessory port available on the
M3902. There are two accessory ports available on the M3903, M3904 and
M3905.