Filter
Top Products
Page 428 of 504 Appendix C: Meridian Modular Telephones add-on modules installation
553-3001-367 Standard 3.00 August 2005
9 Reassemble the telephone by placing the base section on the faceplate
section. Reinstall the five screws.
10 Tighten the screws, reconnect all cords, and place the telephone in its
former position.
11 Refer to Procedure 79 to connect the power supply and data terminal to
the ADO.
End of Procedure
Procedure 79
Installing the M2317 data terminal
1 Connect the RS-232-C interface connector from the data terminal to the
matching header connector in the back of the telephone. See Figure 84
on page 429.
2 Insert the two captive screws in the connector body into the threaded
holes in the header connector. Secure them tightly to prevent accidental
disconnection during data terminal operation.
3 Insert the keyed power supply plug securely into the 5-pin power
connector located to the right of the RS-232-C connector.
4 Plug the wall transformer into the nearest AC outlet. The data terminal is
now operational.
Note 1: If an ADM3, ADM5, or ADM11 terminal is used in conjunction
with the RS-232-C connector in the Asynchronous Data Option, pin 22 in
the RS-232-C cable must be disconnected. These ADM terminals will go
into test mode if this pin is not disconnected.
Note 2: A special 9-pin connector is required to connect the Apple
Macintosh to the RS-232-C connector in the Meridian Modular Telephone
Asynchronous Data Option. The connections are shown in Table 70 on
page 429.
End of Procedure