Filter
Top Products
Page 484 of 504 Appendix E: M3110, M3310, and M3820 telephones
553-3001-367 Standard 3.00 August 2005
4 Plug the headset TELADAPT connector into the socket on the base of the
telephone marked with a headset icon.
5 Route the headset cord through the channels at the side of the telephone.
6 Replace the footstand in the same position and tighten both screws (if
previously fitted).
7 Place the telephone back on the desk in the normal operating position.
8 Plug the line cord connector back into the connecting block.
End of Procedure
Telephone Positions
Your Meridian telephone can be installed in three different positions - two
desktop positions and a wall-mount position. The two desktop positions
provide two different angles for the telephone on the desktop. The telephone
is supplied in the steeper of the two positions. Follow Procedure 84 for
adjustment to the shallow-angel position, and Procedure 85 on page 485 for
wall mounting.
Procedure 84
Adjusting the telephone to the
desktop shallow-angle position
The procedure to change to the more shallow angle is as follows:
1 Unplug the line cord from the connecting block.
2 Remove the handset and place the telephone upside down on top of a
level, solid work surface covered with soft material or paper to prevent
damage to moveable keys and the telephone face.
3 Remove the 2 screws from the telephone footstand (if fitted) to separate
the footstand from the telephone.
4 Snap the footstand back into place using the alternate slots located closer
to the back of the set and tighten the screws (if previously fitted).
5 Place the telephone back on the desk in the normal operating position.
6 Plug the line cord connector back into the connecting block.
End of Procedure