Filter
Top Products
Page 46 of 504 Attendant consoles
553-3001-367 Standard 3.00 August 2005
5 Raise and hold the top cover to remove the single cable connector. The
alerter cable does not need to be removed (see Figure 4 on page 38).
Remove the top cover and place it upside down to the left of the attendant
console.
6 Holes are located in the upper right-hand side of the attendant console’s
main PCB, near grid positions D1, D5, and A5. See Figure 9 on page 47.
Insert one standoff in each of the holes, twisting it until it is secure.
7 Position the ASM board over the J3 connector on the console’s main
PCB. Align the holes on the ASM board with the standoffs, and carefully
work the ASM pin connector onto connector J3 until firmly seated. See
Figure 9 on page 47.
8 Hold the top cover over the attendant console, and reconnect the cable
connector onto the base of the console.
9 Place the top cover on the console. Slide it back and down into place.
Check that all the cables are in the correct positions, and that none are
trapped.
10 Ensure that the volume switch is fully engaged in the correct slider. Hold
the top cover and console base firmly together. Turn the assembly upside
down.
11 Reinsert the 12 screws that secure the top cover to the console base and
tighten.
12 If required, replace the adjustable stand.
13 Reconnect the main system cable to the rear of the console.
14 Test the supervisory console feature to make sure you can now properly
supervise the M2250 attendant console. Refer to M1250/M2250
Attendant Console User Guide.
End of Procedure
CAUTION
Damage to Equipment
Once a standoff is inserted, it cannot be removed. Be
sure to place each standoff in the correct hole on the
main PCB, as shown in Figure 9 on page 47.