Filter
Top Products
Page 356 of 504 Appendix B: Meridian Modular Telephones installation
553-3001-367 Standard 3.00 August 2005
Installation and removal
Install the Meridian Modular Telephones
Follow the steps in Procedure 61 to install the Meridian Modular Telephones
(M2006/2008/2008HF/2616/2216ACD).
Procedure 61
Installing Meridian Modular Telephones
(M2006/M2008/M2008HF/M2616/M2216ACD)
1 Complete the wiring and cross-connections (loop power) before
connecting the telephone to the TELADAPT connector. See Figure 61 on
page 357 and Figure 62 on page 358.
2 Place the telephone upside down on a number of sheets of soft, clean
paper on a solid, level work surface to prevent damage to movable keys
and the telephone’s face.
3 Connect the handset cord (5-conductor TELADAPT connectors) to the
handset and snap it into place (not applicable to M2216ACD).
4 Connect the other end of the handset cord to the connector in the bottom
cover of the telephone. Turn the smooth side of the handset cord up
(away from the telephone bottom cover) before tucking it under the
restraining tab to ensure that the telephone will sit level on the desk after
installation is complete (not applicable to M2216ACD).
5 Connect the line cord to the telephone bottom cover. Route the cord
through the channels.
6 Turn the telephone right side up and place it in the normal operating
position.
7 Print the directory number on the designation card. Using a paper clip,
remove the number lens from the telephone. Insert the designation card
and snap the lens back into place.
8 Designate the feature keys.
9 Insert the line cord TELADAPT connector into the connecting block (jack)
and snap it into place.
10 Perform the self-test (see Procedure 62 on page 358) and acceptance
test procedures. See LD 31 in the Software Input/Output: Administration
(553-3001-311).