Polycom 9000-Series Telephone User Manual


 
Programming
2-32
During Centralized Telephone Programming, the display phone at extension 10 or
11 takes on the characteristics of the telephone being programmed, including any
System Programming settings and lines assigned to the phone. If you have any
34-button phones in the system, you must use a 34-button display phone to
program since an 18-button phone
cannot
be used to program a 34-button phone.
Also, if your system has both PARTNER-model and MLS-model phones, it is
recommended that you use a PARTNER-model display phone at the programming
extension.
To program a phone from extension 10 or 11, use the following procedure:
1. Place the Programming Overlay over the dialpad of the system display
phone at extension 10 or 11—see ‘‘Programming Overlays’’ on page 2-21 for
more information.
2. To start programming:
a. Press
f 0 0. A display similar to the following appears:
PROGRAM EXTENSION 10
(If you are programming from extension 11, “11" displays instead of
“10.”)
b. Press
s. A display similar to the following appears:
10 Enter Extension Name
This display is for the Extension Name Display feature. When you
are entering Centralized Telephone Programming mode, skip it by
moving on to Step 2c.
c. Press
s again. The display reads:
SYSTEM PROGRAM
d. Press
c. A display similar to the following appears:
CENTRAL TELEPHONE PROG
Extension:
3. Dial the extension number of the telephone to be programmed.
The green lights next to buttons on which lines or pools are assigned show
the current Line Ringing settings; remaining buttons can be programmed
with telephone numbers, extension numbers, or system features.
4. At this point, program the features that must use Centralized Telephone
Programming.
For
all phones
, these features must now be programmed:
Use Automatic Line Selection to change the order in which the
telephone selects a line or pool when the user picks up the handset.
(If you want to change Automatic Line Selection for an extension,
you must do so immediately after you enter programming mode and
dial the extension number.)