Polycom 9000-Series Telephone User Manual


 
Feature Reference
5-270
Touch-Tone Enable (F08)
Description
This feature is available only on system phones.
This feature lets a system phone user send touch-tone signals on an outside call
over a rotary line. For example, a user may need to dial touch-tone digits while on
a call to a bank-by-phone service.
Related Procedures
You must use Dial Mode (#201) to identify rotary lines to the system.
To activate this feature from within a number stored on an Auto Dial button
or as part of a Speed Dial number, press
& when storing the number—
see Special Dialing Functions.
Considerations
This feature is needed only when dialing on a rotary line.
Use Touch-Tone Enable only
after
a call is connected. For example, use
this feature after dialing a bank-by-phone service that requires you to dial
touch-tone digits.
You can program a Touch-Tone Enable button on a system phone to turn
on Touch-Tone Enable with one touch.
This feature cannot be used with Call Screening (F25).
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To program a Touch-Tone Enable button:
1. Press
f 0 0 s s c at extension
10 or 11.
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button.
4. Press
f 0 8.
5. Program another button for this extension or exit programming mode.
Using
From a system phone, press the programmed button or press f
0 8
when
you need to enter touch-tone digits. Touch-Tone Enable stays in effect until you
hang up.