Filter
Top Products
Personal Speed Dial Numbers
5-211
Valid Entries
Any phone number—up to 28 characters consisting of the digits 0–9, *, #, and
special dialing functions that you can access by pressing
h (Pause),!
(Stop),
S (Recall), and & (Touch-Tone Enable)—assigned to codes 80
through 99.
No number assigned to any code
✔
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To program Personal Speed Dial numbers:
1. Press
f 0 0 s s c at extension
10 or 11.
2. Dial the number of the extension to be programmed with this feature.
3. Select a two-digit code by pressing
f and dialing two digits between
80 and 99. For example, to select code 81, press
f 8 1.
If a number is assigned already to the code, the number appears on the
display. If no number is assigned to the code, the display reads:
Blank
4. Enter the phone number exactly as you would dial it.
5. At this point:
■ To program another Personal Speed Dial number, start from Step 3.
■ To program over an existing number, enter the new number after
selecting the two-digit code.
■ To remove a Personal Speed Dial number, enter the number’s
two-digit code and press
! once.
6. Continue programming or exit programming mode.
Using
System Phone
You can lift the handset or press S before dialing:
1. If you want to call on a specific line, press the line button (or press
i
8 and the two-digit line number) or if you want to call using a specific pool,
press the pool button (or press
i and the three-digit pool access
code).
2. Press
f.