Polycom 9000-Series Telephone User Manual


 
Line Assignment (#301)
5-175
Considerations
You cannot assign a line that belongs to a pool as an individual line on that
pooled extension.
A line must be assigned to a button with lights. If a line is assigned to a
button
without
lights, you cannot access that line, nor can you program
anything else on the button.
You can assign multiple lines (up to 19) to a standard phone, but a
single-line phone can handle only one call at a time. To make a call, a user
lifts the handset and dials 9 at the intercom dial tone; the system selects
the first available line based on the Automatic Line Selection
programmed for the extension. (Alternatively, the user can use Direct Line
Pickup to access a specific line.)
Valid Entries
1 = Assigned
2 = Not Assigned
3 = Select Button (then press a line button to assign the line to that button)
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To assign lines to a specific extension:
1. Press
f 0 0 s s # 3 0 1 at extension
10 or 11.
2. Enter the extension number to be programmed. For example, to program
extension 15, press
1 5.
The red light next to each button that has a line assigned is on steady; the
red light next to each button that has a pool assigned flashes. To remove
all existing line assignments, press
r
before selecting a
line.
3. Enter the line number to be assigned. For example, to select line 1, press
0 1.