Polycom 9000-Series Telephone User Manual


 
Overview
1-16
Intercom Autodialers
PARTNER-model system phones support the PARTNER-CA48 Call Assistant
Intercom Autodialer at extensions 10 and 11. The autodialer provides Auto Dial
buttons for all of the extensions in your system. The status lights next to each
button also indicate calling activity at that extension. Users can program the Auto
Dial buttons for either intercom ringing, voice signaling, or manual signaling. (Note
that each user can have only one Auto Dial button—either on the system phone or
on the autodialer—for another extension in the system.) The Auto Dial buttons
allow the user to dial, signal, or transfer calls to system extensions with one touch.
For more information about Auto Dial buttons, see ‘‘Auto Dialing’’ on page 5-17.
Standard Telephones
You can also use industry-standard single-line rotary or touch-tone telephones,
including feature phones with built-in feature buttons and lights, with the system.
This guide refers to such telephones as
standard phones
. Lucent
Technologies-certified standard phones are recommended.
The following Lucent Technologies phones can make use of the system’s
message-waiting capability:
2500 YMGL Single-Line Analog Telephone Set
8101 Analog Telephone
8101M Analog Telephone
(This model is recommended.)
8102 Analog Telephone
8110 Analog Telephone
7102 Plus Analog Voice Terminal
Check with your local Lucent Technologies Representative or local Authorized
Dealer to find out whether other standard phones with message-waiting lights will
work.
NOTE:
For message waiting capability, you must connect standard phones with
LED-compatible message-waiting lights, to a PARTNER ACS processor
module, 308EC module, or to Release 3.0 (R3.0) or later 206 modules. This
message-waiting capability does not work with standard phones with
neon-type message-waiting lights.