Filter
Top Products
Direct Line Pickup—Idle Line (I8LL)
5-111
Direct Line Pickup—Idle Line (I8LL)
Description
This feature allows users to access a specific outside line (where
LL
is a system
line number) when the line is not in use. This feature is useful for accessing a line
that is not assigned to the phone.
Related Features
■ If a line is
in use,
users cannot access it with this feature (they hear busy
tone). For information about accessing a ringing or held call, or joining a
call in progress, see Direct Line Pickup—Active Line.
■ If Line Access Restriction (#302) or pool Access Restriction (#315) is
set to No Access or In Only for a line assigned to an extension or lines
within a pool, a user at the restricted extension hears busy tone if Direct
Line Pickup is used to access that line to place a call.
Considerations
■ This procedure applies to individual lines. If you have a pooled extension
and you want to access lines in pools that are not assigned to your
extension, dial the pool access code at intercom dial tone.
■ You can program a Direct Line Pickup—Idle Line button on a system phone
to pick up a line by pressing the button then dialing the two-digit line
number.
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To program a Direct Line Pickup—Idle Line button:
1. Press
f 0 0 s s c at extension
10 or 11.
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button.
4. Press left
i 8.
5. Program another button for this extension or exit programming mode.